Osmio Zero 2.0 Reverse Osmosis System

Osmio Zero 2.0 – The Ultimate All-in-One Reverse Osmosis Water Purifier & Kettle. For a limited time, the Osmio Zero 2.0 comes with all filters pre-installed so you just get it out the box and fill the tank with water to start, plus you get free Empty Filters (for descaling and sanitizing) and a 500ml Osmio Sanser Sanitising Spray - only while stocks last!

The Osmio Zero 2.0 is a smart, compact, and highly efficient reverse osmosis water filter and instant kettle in one. With no installation required, it provides purified water at ambient, hot, and near-boiling temperatures—perfect for homes, offices, and travel.

✔ Advanced Reverse Osmosis Filtration – Delivers high-quality purified water
✔ No Installation Needed – Just plug in and enjoy
✔ Upgraded Design – New heating element & redesigned supply tank (UK plug only)
✔ Easy Maintenance – Quick filter changes & convenient descaling/sanitisation
✔ Sustainable Choice – Reduces plastic waste and harmful chemicals
✔The only pure water kettle on the market and 80% more energy efficient than a regular kettle
✔ Thousands of times purer than traditional gravity filters or jug filters. The most efficient RO in the world, only 1 litre of waste for every 5 litres of water!
✔ Replace your kettle by also producing reverse osmosis quality water, ambient, warm, hot, or boiling at your fingertips!
✔Filters cold water and has a boiler for dispensing instant nearly boiling water
✔Very compact and can be put anywhere
✔ Uses flow monitoring to detect filter life and alarm, plus fail safe built in to never dispense bad water.

WATER TEMPERATURES

The system can provide the following osmotic level water with organic calcium and magnesium active ceramic:

Normal temperature water (approx. 25 ° C), ideal for direct drinking
Warm water (40 ° C - 50 ° C) ideal for lukewarm water
Hot water (80 ° C - 88 ° C) ideal for coffee
Hot Water 100C setting is a nearly boiling water (90 ° C - 95 ° C) ideal for tea - PLEASE NOTE - the system reaches 100% but then travels through the route to the dispenser and loses some degrees. By using a thermometer at the very top where the water comes out, you will measure around 90- 95C. A great tip for hotter dispensing is first to select 100°C Setting, and let the water get hot, and make your mug hot. Then press stop and empty that out, then go again with a new 100°C press and the results are much better.

TEST REPORT:

WEIGHT & DIMENSIONS:
Height: 38 cm
Width: 18 cm
Depth: 41 cm (approx 50 cm including drip tray)
7kg weight

Maximum Bottle Height with Tray in position: 22cm
Maximum Bottle Height without Tray in position: 24cm

CAPACITY:
Up to 190 litres daily (at 20 ° C water temperature)
Flow Rate: 7.8 Litres Per Hour (at 20 ° C water temperature)
Capacity Water tank capacity: 5 litres to fill
Capacity Osmosis water tank: 1.5 litres approximately - 8-20 minutes to refill (depending on how blocked the composite carbon and membrane filters are)

POWER: FEED WATER REQUIREMENTS:
Temperature 4 - 40 oC
pH 6.5 - 8.5
Turbidity < 3 NTU
TDS < 270 PPM
Hardness < 250 PPM CaCO3
Chloride < 250 PPM
Free Chlorine < 0.7 PPM
Iron < 0.1 PPM (or 100 ug/l )
Manganese < 0.050 PPM (or 50 ug/l )
Silica < 0.1 PPM
Chemical Oxygen Demand < 5 PPM O2
Total Bacteria Count < 50 CFU / mL
E. Coli < 3 CFU

Power connection required UK & EU models
AC 220-240V, 50Hz
Power Rating: 2200W - 2600W
Nominal heating power 2180W - 2580W
The osmosis system consumes in standby only under 0.5 watts/hr. thanks to the ERP2 power supply

The system must not be used with any transformers, extensions or plug adapters. An unstable connection will over time, cause heating element failures.
This system must be plugged directly into an electricity socket.
If the system is plugged into a double socket - no other appliances should be used when water is dispensed 65-100C. (Double sockets are 13A rated and you will damage the heating system on an Osmio Zero if you use it with another electrically juicy appliance like a cooker, toaster, microwave etc. Double sockets can be used if you use a light appliance like a phone charger, laptop etc).

Power consumption as below:
Idle 0.0005 kW/hr (1kW/hr every 83 days)
Dispensing ambient (25C) 0.008 kW/hr
Filtering 0.016 kW/hr
Dispensing 65-100C 2.8 kW/hr

System is equipped with booster pump DC 24V and water pump Including flush valve
Integrated automatic shut-off: As soon as the storage tank is filled, the water production stops.
Power cable length approx 138 cm
Normal wear and tear. We suggest the system should be replaced after 5 years.

FILTER CHANGES:
Filter changes recommended by the manufacturer: every 6 months
Quick-Change filter: filter changes are very easy!

Please be aware usage in hard water areas may require more frequent maintenance. Please refer to the manual or ask a member of our team for more information if required.

FILTER PARAMETER: Bacteria, E-coli, Chlorine, Sediments, Nitrates, Fluoride, Limescale, Dissolved Solids (TDS), Hormones, Pharmaceuticals, Heavy Metals